Newrange Gold Corp. announced to provide an update on the ongoing reverse circulation (RC) drilling program at its Pamlico gold project in Nevada. The holes reported herein (P20-92 to 110) were drilled in the Gold Box Canyon, Merritt, and Good Hope areas and demonstrate the extent of shallow oxide gold mineralization across the Pamlico District, covering an area of approximately 0.75 square kilometers. Drilling to the end of hole P20-110 has entailed 6,538 meters and is continuing. Drill holes P20-92 to 98, inclusive, targeted projections of gold-bearing structural zones situated stratigraphically below the most favorable rhyolite - latite tuff contact zones, in the lower reaches of Gold Box Canyon. To test the same or similar horizon as hosts mineralization in the Merritt zone and Pamlico Ridge will require drilling from on top of the ridges to either side of the canyon. Holes P20-92, 93, 94 and 95 were drilled to the southeast and hole P20-96 was drilled to the northwest, all at a -45 degree inclination and specifically targeted mineralization in northeast striking gold-bearing structures exposed in underground workings and at surface, where sampling returned values ranging from 0.6 to more than 20 grams gold per metric tonne (g/t Au). Hole P20-94 was lost in a large breccia zone at 62.5 meters and could not be completed. Hole P20-97 was drilled to the southwest at an inclination of - 45 degrees to test a large northwest striking, southwest dipping high angle fault zone that had returned gold values from 11.8 to more than 16.1 grams in grab samples from exposures in prospect pits and underground workings. Unfortunately, the hole was lost in a large breccia zone before reaching its target. Drilling results indicate that a relatively flat-lying zone of gold mineralization exists near surface, as evidenced by intercepts in holes P20-93, 96 and 98, all of which correlate with previously drilled hole P20-65. While these intercepts average approximately 0.1 g/t Au, they are above 50 meters depth and require follow-up drilling. It is interpreted that this zone correlates with the gold mineralization in the underground workings and that holes P20-92, 94 and 95 may have drilled underneath this horizon. The zone appears to dip shallowly to the east and a series of vertical holes will be required to further test the continuity of the mineralization. Drilling in the Merritt zone comprised a combination of fill-in and step-out holes and continues to expand and confirm gold mineralization peripheral to the Company's 2017 drill holes. Holes P20-99 and P20-107 to 110, inclusive, all encountered significant intercepts of near surface oxide gold mineralization highlighted by hole P20-110, which contained 3.05 meters averaging 4.250 g/t Au within a larger interval averaging 1.250 g/t Au over 10.67 meters from a vertical depth of 16.77 meters, followed by a second interval of gold mineralization averaging 0.742 g/t Au over the 21.35 meters from 53.35 meters vertical depth. Holes 99, 107 and 108 expanded mineralization to the southwest 30 to 40 meters while holes 109 and 110 expanded mineralization 15 to 30 meters in a north-northeast direction. Holes P20-100 to 106, inclusive, and 106A tested gold mineralization in the area of the Good Hope Mine, in the southern portion of Pamlico Ridge. Underground sampling by Newrange in this area in 2019 and 2020 demonstrated good lateral continuity of gold mineralization. Drilling has now confirmed that gold mineralization here is very shallow and locally outcrops as demonstrated by hole P20-104 that intersected 15.24 meters of oxide gold mineralization from surface grading 0.749 g/t Au, including a higher-grade interval from surface grading 3.145 g/t Au over 3.05 meters. All holes were drilled vertically such that the gold zone appears to be approximately 4.6 to 15.2 meters in thickness with a shallow dip to the south-southeast, and it is still open to the northwest, northeast and southeast.