Silver Sands Resources Corp. and Mirasol Resources Ltd. reported results from the initial six diamond drill holes ("DDH"), representing 903 m (32%) of the 2,831 m Phase I exploration program completed in Fourth Quarter 2020 at the Virginia Silver project ("Virginia"), located in Santa Cruz province, Argentina. The DDH completed at Martina and Ely Central clearly show the potential for significant new mineralization outside the current resource area. An additional twelve DDH for 1,928m have assay results pending and will be reported as results are received. SummaryPhase I drilling completed at Virginia in late 2020 tested the potential for new high-grade silver zones to expand on the existing NI 43-101 resource1. All the drilling, except for the holes at the Magi target, focused on potential strike extensions along the known trends that host the current resource and also previously untested, but proximal and related, vein structures. Initial results confirm the potential to identify new well-mineralized structures that do not outcrop on surface. Planning for the Phase II program is progressing well and Mirasol's exploration crew is mobilizing to recommence drilling later this month. The Martina hole MSE-DDH-001 collared 70m to the southeast of the current conceptual pit outline was located to test a significant structural "jog" in the mineralized Martina structure. The drill hole encountered significant Ag mineralization at a depth of 79.5m downhole returning a wide intersection of 33.5m grading at 198 g/t Ag, with a higher-grade section of 17.7m grading 313 g/t Ag. This first hole at Ely Central was collared along the structure within an 850m gap between the Ely South and Ely North conceptual pit shells, some 470m south of the Ely North resource. The hole returned a 12m intercept of 184 g/t Ag, which includes a higher-grade intersection of 4.5m at 442 g/t Ag. This intersection is significant and confirms the potential to grow the current resource base along the Ely structural trend. Drill hole NE-DDH-001 at the Naty Extension target intersected a near surface, wide zone of mineralization from top of the hole at 14m down to 42.75m with an overall intercept of 28.75m grading 55 g/t Ag. The highest-grade intersection in this section returned 2.43m grading 143 g/t Ag, with a peak sample of 244 g/t Ag over 0.7m. This result potentially extends the higher-grade Ag mineralization footprint associated with the Naty conceptual pit 250m to the north. The two previous drill holes at Magi from Mirasol's 2012 drilling intersected interesting low temperature epithermal veining with anomalous Ag values. For example, hole VG-91, the deepest of the previously drilled holes in this target area, returned 8m of 52 g/t Ag. This drilling suggested that Magi may represent a higher elevation in both the Virginia volcanic stratigraphy and the mineralized epithermal column on the eastern most side of the Virginia vein field. Due to the high and cooler epithermal environment, it is to be expected that higher grade silver values should exist at a greater depth. If mineralized shoots do exist at Magi, they will be 100% preserved and not affected by erosion as were the outcropping ore shoots at Julia, on the western side of the vein field. The recently completed drill hole at Magi, MG-DDH-001, was located to test for higher grade Ag grades at moderate depths below the historical drilling. This hole successfully intersected veining at approximately 20m below the vertical extent of the historical drill holes returning 6m of 54 g/t Ag, including 1m at 70 g/t Ag, thus supporting the concept that Ag values are increasing at depth. However, it is not yet clear that the actual vein structure intersected in Magi hole MG-DDH-001 is the down dip extension of the historical intersections or a parallel blind structure located further to the west. A scissor hole, drilled from the east side of the exposed structure, is planned for the Phase II program to verify the geology. Further drilling at Magi is warranted based on the results of this Phase I drilling.